The device operates with a fixed I2C address, but includes a select line to permit multiple device installation. Device chip select is routed through three on board jumpers to permit user selection of the SPIP control line (two of three jumpers must be removed prior to installation). The device is 3.3V operation only, do not operate with the motherboard peripheral voltage select at 5V (unless the 3.3V level translator peripheral is installed, coming soon). Use with the E3 Remote Mount Kit to position the sensor in an optimum measurement position. For additional information, refer to the SI7005 data sheet.
| 311-008-temp-rh-board.pdf |
